Chapter 11 Control Panel: Maintenance
NAS Series User’s Guide
187
Figure 152 Control Panel > Service > Maintenance > Configuration Backup > Configuration Restore
Click Browse to locate a previously-saved configuration file. Then click Restore to load the previously-
saved configuration file to the NAS. This replaces your current NAS configuration settings with the settings
in the previously-saved configuration file.
A pop-up screen appears asking you to confirm. Click OK to continue or Cancel to quit.
11.5.3 Factory Reset
Click Control Panel > Service > Maintenance > Configuration Backup > Factory Reset to open the
following screen.
To Next Page
Loading...
