Chapter 11 Control Panel: Maintenance
NAS Series User’s Guide
185
Figure 150 Control Panel > Service > Maintenance > Log > Report Config: Syslog Server Setting
The following table describes the labels in this screen.
11.5 Configuration Backup Screens
Use these screens to backup or restore the NAS configuration settings. You can also reset your device
settings back to the factory default.
11.5.1 Configuration Backup
Click Control Panel > Service > Maintenance > Configuration Backup to open the following screen.
Click Backup to save the current configuration of the NAS to your computer. A pop-up screen appears
asking you to confirm.
Table 110 Control Panel > Service > Maintenance > Log > Report Config: Syslog Server Setting
LABEL DESCRIPTION
Enable Syslog
Server
Check this to enable syslog server.
Server Address Enter the syslog server address you want the NAS to use for its log alerts.
Syslog Select the type of log alerts you want to receive in your e-mail. Select All Logs to include all
types of log alerts.
Apply Click this to save your changes.
Cancel Click this to return to the previous screen without saving.
To Next Page
Loading...
