Chapter 16 Backup Planner
NAS Series User’s Guide
274
Step 4 Schedule and Options
Use this screen to specify the schedule for the backup job. The backup job automatically runs
according to the schedule that you set in this screen. You can also use this screen to specify
compression and encryption if you are doing an archive backup or a synchronization backup to a
remote target.
Remote Select this to back up to another device.
For Archive:
The remote device can be another NAS in the network. Fill in the following fields in order to be
able to access it.
• Remote NAS Address
• Username
•Password
•Share Name
Click Test Connection to see if your NAS can communicate with the remote device.
For Synchronization:
The remote device must be another NAS compatible with the NAS’s synchronization feature.
Fill in the following fields in order to be able to access it.
• Remote NAS Address
• Username (always “admin”)
• Remote Admin’s Password
Click Show target content to connect to the remote NAS so you can select the target share for
the backup.
For Rsync:
The remote device must be a NAS that supports rsync or a computer running the rsync utility.
Fill in the following fields in order to be able to access it.
• Remote NAS Address
• Username (always “admin”)
• Remote Admin’s Password
Click Show target content to connect to the remote NAS or computer so you can select the
target folder for the backup.
Backup
destination folder
This shows the path of the backup destination folder you selected.
Back Click this to go back to the previous screen.
Next Click this to go to the next screen.
Cancel Click this to close the screen without saving.
Table 153 Backup Planner > Backup: Add Job Step 3 Destination (continued)
LABEL DESCRIPTION
To Next Page
Loading...
