Chapter 16 Backup Planner
NAS Series User’s Guide
282
Figure 227 Backup Planner > Backup > Restore Job: Step 1 Source: Enter Password (Backup Job)
If you set the NAS to restore a backup based on the selected backup file(s) in the previous screen, the
following screen displays. Select the folder where the backup you want to restore is located and the
time point at which the backup job was done. Click Next to continue.
Figure 228 Backup Planner > Backup > Restore Job: Step 1 Source (Backup File)
A pop-up screen displays. Enter the password if you configured to encrypt the backup files and click
Apply. Otherwise, click Cancel to proceed.
Figure 229 Backup Planner > Backup > Restore Job: Step 1 Source: Enter Password (Backup File)
Restore Job: Step 2 Folders/Files to Restore
Select the backup files or the folder you want to restore. The screen shows the path of the file(s) or
folder(s) you selected. Click Next to continue.
To Next Page
Loading...
