Chapter 5 Storage Manager
NAS Series User’s Guide
86
5.4.2.1 Create a New Target
Click Create in the iSCSI Targets section of the Storage Manager > iSCSI screen to open the screens as
shown.
Note: The NAS can create only 10 targets at maximum.
Delete Click this to open the following screen where you can delete an existing target.
Key in DELETE and click Delete to remove an existing target. Click Cancel to close this screen.
Info Click this item to check detailed information about the target.
Name - Displays the created target name.
IQN - Displays the target’s iSCSI Qualified Name (IQN) format.
Allowed initiator (IQN) - Displays the allowed initiator’s iSCSI Qualified Name (IQN) format.
Authentication - Displays the authentication method the target applies.
CRC Checksum - Displays the data transmission error detecting technique.
Maximum receive segment bytes - Displays the maximum data segment length in bytes that the
iSCSI target can receive.
Maximum send segment bytes - Displays the maximum data segment length in bytes that the iSCSI
target can send. This feature is for the NAS326 only.
Mapped iSCSI Luns - Displays the LUNs mapped with the target.
Table 40 Storage Manager > iSCSI > iSCSI Targets (continued)
LABEL DESCRIPTION
To Next Page
Loading...
