Chapter 12 AP Profile
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
122
Figure 80 Configuration > Object > AP Profile > SSID > Security List > Add/Edit Security Profile> Security
Mode: wpa3
The following table describes the labels in this screen.
Table 47 Configuration > Object > AP Profile > SSID > Security List > Add/Edit Security Profile> Security
Mode: wpa3
LABEL DESCRIPTION
General Settings
Profile Name Enter up to 31 alphanumeric characters for the profile name. This name is only visible in
the Web Configurator and is only for management purposes. Spaces and underscores
are allowed.
Security Mode Select a security mode from the list: none, enhanced-open, wep, wpa2, wpa2-mix or
wpa3.
enhanced-open uses Opportunistic Wireless Encryption (OWE) which encrypts the
wireless connection when possible.
Authentication Settings
Enterprise Select this to enable 802.1X secure authentication with a RADIUS server.
ReAuthentication
Timer
Enter the interval (in seconds) between authentication requests. Enter a 0 for unlimited
time.
Personal This field is available when you select the wpa2, wpa2-mix or wpa3 security mode.
Select this option to use a Pre-Shared Key (PSK) with WPA2 encryption or Simultaneous
Authentication of Equals (SAE) with WPA3 encryption.
Pre-Shared Key Enter a pre-shared key of between 8 and 63 case-sensitive ASCII characters (including
spaces and symbols) or 64 hexadecimal characters.
Transition Mode This option only displays if you set the Security Mode to wpa3 or enhanced-open. This
option is always enabled for backwards compatibility. This creates two virtual APs (VAPs)
with a primary (wpa3 or enhanced-open) and fallback (wpa2 or none) security method.
To Next Page
Loading...
