Chapter 10 Wireless
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
82
10.3 Rogue AP
Use this screen to enable Rogue AP Detection and import/export a rogue or friendly AP list in a txt file.
Click Configuration > Wireless > Rogue AP to access this screen.
Enable WDS Wireless
Bridging
If you set the Zyxel Device as a root AP, the radio that’s bridging with the Zyxel Device
should be in repeater mode.
Be careful to avoid bridge loops. For example, if your root AP and the Zyxel Device are
connected to a switch, and they’re also connected to each other using a WiFi connection.
This will create bridge loops.
This field is available only when the radio is in Repeater mode. Select this to enable WDS
wireless bridging on the Zyxel Device. See Section 1.2 on page 12 for more information on
Wireless Distribution System (WDS).
Uplink Selection
Mode
This field is available only when the radio is in Repeater mode.
Select AUTO to have the Zyxel Device automatically use the settings in the applied WDS
profile to connect to a root AP or repeater.
Select Manual to have the Zyxel Device connect to the root AP or repeater with the MAC
address specified in the Radio 1 Uplink MAC Address field.
Setup Wireless Bridge
Vlan ID
Click this to show the Wireless Bridge Vlan Setting pop-up window. This link is available only
when the radio is in Root AP or Repeater mode.
Wireless Bridge Vlan Setting
Add Click this to add an entry in the table.
Remove Select an entry and click this to remove the selected entry.
# This field is a sequential value. It is not associated with any VLAN ID.
Wireless Bridge
Vlan ID
Enter a VLAN ID for the wireless bridge. The VLAN IDs you set on your root AP should be the
same as the VLAN ID you set here. See Section 1.2 on page 12 for more information on
wireless bridge.
OK Click OK to save your changes back to the Zyxel Device.
Close Click Close to close the pop-up window without saving your changes.
Max Output Power Enter the maximum output power (between 0 to 30 dBm) of the Zyxel Device in this field. If
there is a high density of APs in an area, decrease the output power of the Zyxel Device to
reduce interference with other APs.
Note: Reducing the output power also reduces the Zyxel Device’s effective
broadcast radius.
MBSSID Settings
Edit Click Edit ( )to open a screen where you can modify the entry’s settings. In some tables
you can just click a table entry and edit it directly in the table. For those types of tables small
red triangles display for table entries with changes that you have not yet applied.
# This field shows the index number of the SSID
SSID Profile This field shows the SSID profile that is associated with the radio profile.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
Table 28 Configuration > Wireless > AP Management (continued)
LABEL DESCRIPTION
To Next Page
Loading...
