Chapter 10 Wireless
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
81
Uplink Selection
Mode
This field is available only when the radio is in Repeater mode.
Select AUTO to have the Zyxel Device automatically use the settings in the applied WDS
profile to connect to a root AP or repeater.
Select Manual to have the Zyxel Device connect to the root AP or repeater with the MAC
address specified in the Radio 1 Uplink MAC Address field.
Setup Wireless Bridge
Vlan ID
Click this to show the Wireless Bridge Vlan Setting pop-up window. This link is available only
when the radio is in Root AP or Repeater mode.
Wireless Bridge Vlan Setting
Add Click this to add an entry in the table.
Remove Select an entry and click this to remove the selected entry.
# This field is a sequential value. It is not associated with any VLAN ID.
Wireless Bridge
Vlan ID
Enter a VLAN ID for the wireless bridge. The VLAN IDs you set on your root AP should be the
same as the VLAN ID you set here. See Section 1.2 on page 12 for more information on
wireless bridge.
OK Click OK to save your changes back to the Zyxel Device.
Close Click Close to close the pop-up window without saving your changes.
Max Output Power Enter the maximum output power (between 0 to 30 dBm) of the Zyxel Device in this field. If
there is a high density of APs in an area, decrease the output power of the Zyxel Device to
reduce interference with other APs.
Note: Reducing the output power also reduces the Zyxel Device’s effective
broadcast radius.
MBSSID Settings
Edit Click Edit icon ( )to open a screen where you can modify the entry’s settings. In some
tables you can just click a table entry and edit it directly in the table. For those types of
tables small red triangles display for table entries with changes that you have not yet
applied.
# This field shows the index number of the SSID
SSID Profile This field displays the SSID profile that is associated with the radio profile.
Radio 2 Setting
Radio 2 Activate This displays if the Zyxel Device has a second radio.
Select the check box to enable the Zyxel Device’s second radio.
Radio 2 OP Mode This displays if the Zyxel Device has a second radio. Select the operating mode for radio 2.
AP Mode means the radio can receive connections from wireless clients and pass their data
traffic through to the Zyxel Device to be managed (or subsequently passed on to an
upstream gateway for managing).
Root AP means the radio acts as an AP and also supports the wireless connections with
other APs (in repeater mode) to form a WDS to extend its wireless network.
Repeater means the radio can establish a wireless connection with other APs (in either root
AP or repeater mode) to form a WDS.
Radio 2 Profile This displays if the Zyxel Device has a second radio. Select the radio profile the radio uses.
Note: You can only apply a 5G AP radio profile to radio 2. Otherwise, the second
radio will not be working.
Radio 2 WDS Profile This field is available only when the radio is in Root AP or Repeater mode.
Select the WDS profile the radio uses to connect to a root AP or repeater.
Table 28 Configuration > Wireless > AP Management (continued)
LABEL DESCRIPTION
To Next Page
Loading...
