NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
69
CHAPTER 9
Network
9.1 Overview
This chapter describes how you can configure the management IP address and VLAN settings of your
Zyxel Device.
The Internet Protocol (IP) address identifies a device on a network. Every networking device (including
computers, servers, routers, printers, etc.) needs an IP address to communicate across the network.
These networking devices are also known as hosts.
Figure 45 IP Setup
The figure above illustrates one possible setup of your Zyxel Device. The gateway IP address is 192.168.1.1
and the managed IP address of the Zyxel Device is 192.168.1.2 (default), but if the Zyxel Device is
assigned an IP address by a DHCP server, the default (192.168.1.2) will not be used. The gateway and
the Zyxel Device must belong in the same IP subnet to be able to communicate with each other.
9.1.1 What You Can Do in this Chapter
• The IP Setting screen (Section 9.2 on page 69) configures the Zyxel Device’s LAN IP address.
• The VLAN screen (Section 9.3 on page 71) configures the Zyxel Device’s VLAN settings.
• The NCC Discovery screen (Section 9.4 on page 74) configures the Zyxel Device’s Nebula Control
Center (NCC) discovery settings.
9.2 IP Setting
Use this screen to configure the IP address for your Zyxel Device. To access this screen, click
Configuration > Network > IP Setting.
To Next Page
Loading...
