Chapter 15 System
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
147
The following table describes the labels in this screen.
15.3 Date and Time
For effective scheduling and logging, the Zyxel Device system time must be accurate. The Zyxel Device
has a software mechanism to set the time manually or get the current time and date from an external
server.
To change your Zyxel Device’s time based on your local time zone and date, click Configuration >
System > Date/Time. The screen displays as shown. You can manually set the Zyxel Device’s time and
date or have the Zyxel Device get the date and time from a time server.
Table 61 Configuration > System > Host Name
LABEL DESCRIPTION
System Name Choose a descriptive name to identify your Zyxel Device device. This name can be up to 64
alphanumeric characters long. Spaces are not allowed, but dashes (-) underscores (_) and
periods (.) are accepted.
System Location Specify the name of the place where the Zyxel Device is located. You can enter up to 60
alphanumeric and '()’ ,:;?! +-*/= #$%@ characters. Spaces and underscores are allowed. The
name should start with a letter.
Domain Name Enter the domain name (if you know it) here. This name is propagated to DHCP clients
connected to interfaces with the DHCP server enabled. This name can be up to 254
alphanumeric characters long. Spaces are not allowed, but dashes “-” are accepted.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
