ZyXEL Communications NWA90AX - 18.3 Remote Capture

Chapter 18 Diagnostics
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
189
Figure 122 Maintenance > Diagnostics: Debug Information Collector
18.3 Remote Capture
Use this screen to capture network traffic going through the Zyxel Device connected to the Zyxel
gateway or ZyWALL, and output the captured packets to a packet analyzer (also known as network or
protocol analyzer) such as Wireshark.
Click Maintenance> Diagnostics> Remote Capture to open the Remote Capture screen.
Figure 123 Maintenance > Diagnostics> Remote Capture
The following table describes the labels in this screen.
Table 76 Maintenance > Diagnostics> Remote Capture
LABEL DESCRIPTION
Server Port Enter the number of the server port you want the packet analyzer to connect to in order to
capture traffic going through the Zyxel Device. The default port number is 2002.
Start Click this button to allow the packet analyzer to start capturing traffic going through the Zyxel
Device.
Stop Click this button to stop the packet analyzer from capturing traffic going through the Zyxel
Device.