Chapter 15 System
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
162
15.5.5 Examples of Secure Telnet Using SSH
This section shows two examples using a command interface and a graphical interface SSH client
program to remotely access the Zyxel Device. The configuration and connection steps are similar for
most SSH client programs. Refer to your SSH client program user’s guide.
15.5.5.1 Example 1: Microsoft Windows
This section describes how to access the Zyxel Device using the Secure Shell Client program.
1 Launch the SSH client and specify the connection information (IP address, port number) for the Zyxel
Device.
2 Configure the SSH client to accept connection using SSH version 2.
3 A window displays prompting you to store the host key in you computer. Click Yes to continue.
Figure 107 SSH Example 1: Store Host Key
Enter the password to log in to the Zyxel Device. The CLI screen displays next.
15.5.5.2 Example 2: Linux
This section describes how to access the Zyxel Device using the OpenSSH client program that comes
with most Linux distributions.
1 Test whether the SSH service is available on the Zyxel Device.
Enter “telnet 192.168.1.2 22” at a terminal prompt and press [ENTER]. The computer attempts to
connect to port 22 on the Zyxel Device (using the default IP address of 192.168.1.2).
A message displays indicating the SSH protocol version supported by the Zyxel Device.
To Next Page
Loading...
