Chapter 6 Dashboard
NWA50AX/NWA90AX/NWA55AXE Series User’s Guide
47
Boot Status This field displays details about the Zyxel Device’s startup state.
OK - The Zyxel Device started up successfully.
Firmware update OK - A firmware update was successful.
Problematic configuration after firmware update - The application of the configuration
failed after a firmware upgrade.
System default configuration - The Zyxel Device successfully applied the system default
configuration. This occurs when the Zyxel Device starts for the first time or you intentionally
reset the Zyxel Device to the system default settings.
Fallback to lastgood configuration - The Zyxel Device was unable to apply the startup-
config.conf configuration file and fell back to the lastgood.conf configuration file.
Fallback to system default configuration - The Zyxel Device was unable to apply the
lastgood.conf configuration file and fell back to the system default configuration file
(system-default.conf).
Booting in progress - The Zyxel Device is still applying the system configuration.
Management
Mode
This shows whether the Zyxel Device is set to work as a stand alone AP.
Cloud Control Status This field displays:
• The Zyxel Device Internet connection status.
• The connection status between the Zyxel Device and NCC.
• The Zyxel Device registration status on NCC.
Mouse over the circles to display detailed information.
To pass your Zyxel Device management to NCC, first make sure your Zyxel Device is
connected to the Internet. Then go to NCC and register your Zyxel Device. You can also
view this information in Configuration > Network > NCC Discovery.
1. Internet
Green - The Zyxel Device is connected to the Internet.
Orange - The Zyxel Device is not connected to the Internet.
2. Nebula
Green - The Zyxel Device is connected to NCC.
Orange - The Zyxel Device is not connected to NCC.
3. Registration
Green - The Zyxel Device is registered on NCC.
Gray - The Zyxel Device is not registered on NCC.
Note: All circles will gray out if you disable Nebula Discovery.
Nebula
Discovery
Slide the switch to the right to enable NCC discovery on the Zyxel Device. The Zyxel Device
will connect to NCC and change to the NCC management mode if it:
• is connected to the Internet.
• has been registered on NCC.
Interface Status
Summary
If an Ethernet interface does not have any physical ports associated with it, its entry is
displayed in light gray text. Click the Detail icon to go to a (more detailed) summary screen
of interface statistics.
Name This field displays the name of each interface.
Table 14 Dashboard (continued)
LABEL DESCRIPTION
To Next Page
Loading...
