Chapter 6 Wireless
P-661HNU-Fx User’s Guide
124
Click Network Setting > Wireless > WPS. The following screen displays. Select
Enable and click Apply to activate the WPS function. Then you can configure the
WPS settings in this screen.
Figure 30 Network Setting > Wireless > WPS
The following table describes the labels in this screen.
Table 19 Network Setting > Wireless > WPS
LABEL DESCRIPTION
Enable WPS Select Enable to activate WPS on the ZyXEL Device.
Add a new device with WPS Method
Method 1PBC Use this section to set up a WPS wireless network using Push Button
Configuration (PBC).
WPS Click this button to add another WPS-enabled wireless device (within
wireless range of the ZyXEL Device) to your wireless network. This
button may either be a physical button on the outside of device, or a
menu button similar to the WPS button on this screen.
Note: You must press the other wireless device’s WPS button
within two minutes of pressing this button.
Method 2 PIN Use this section to set up a WPS wireless network by entering the PIN
(Personal Identification Number) of the client into the ZyXEL Device.
To Next Page
Loading...
