Chapter 6 Wireless
P-661HNU-Fx User’s Guide
123
6.4 The WPS Screen
Use this screen to configure WiFi Protected Setup (WPS) on your ZyXEL Device.
WPS allows you to quickly set up a wireless network with strong security, without
having to configure security settings manually. Set up each WPS connection
between two devices. Both devices must support WPS. See Section 6.7.6.3 on
page 135 for more information about WPS.
Note: The ZyXEL Device applies the security settings of the SSID1 profile (see
Section 6.2 on page 113). If you want to use the WPS feature, make sure you
have set the security mode of SSID1 to WPA-PSK, WPA2-PSK or No Security.
Hide SSID Select this check box to hide the SSID in the outgoing beacon frame
so a station cannot obtain the SSID through scanning using a site
survey tool.
BSSID This shows the MAC address of the wireless interface on the ZyXEL
Device when wireless LAN is enabled.
Security Level
Security Mode Select Basic (WEP) or More Secure (WPA(2)-PSK, WPA(2)) to
add security on this wireless network. The wireless clients which
want to associate to this network must have same wireless security
settings as the ZyXEL Device. After you select to use a security,
additional options appears in this screen.
Or you can select No Security to allow any client to associate this
network without any data encryption or authentication.
See Section 6.2.1 on page 115 for more details about this field.
Apply Click Apply to save your changes.
Back Click Back to exit this screen without saving.
Table 18 Wireless > More AP: Edit
LABEL DESCRIPTION
To Next Page
Loading...
