Chapter 10 Quality of Service (QoS)
P-661HNU-Fx User’s Guide
180
10.3 The Queue Setup Screen
Use this screen to configure QoS queue assignment. Click Network Setting >
QoS > Queue Setup to open the screen as shown next.
Figure 71 Network Setting > QoS > Queue Setup
The following table describes the labels in this screen.
Table 38 Network Setting > QoS > Queue Setup
LABEL DESCRIPTION
Add new
Queue
Click this to create a new entry.
# This is the index number of this entry.
Status Select the check box to enable the queue.
Name This shows the descriptive name of this queue.
Interface This shows the name of the ZyXEL Device’s interface through which traffic
in this queue passes.
Priority This shows the priority of this queue.
Weight This shows the weight of this queue.
Buffer
Management
This shows the queue management algorithm used by the ZyXEL Device.
Rate Limit
(kbps)
This shows the maximum transmission rate allowed for traffic on this
queue.
Modify Click the Edit icon to edit the queue.
Click the Delete icon to delete an existing queue. Note that subsequent
rules move up by one when you take this action.
Apply Click Apply to save your changes.
Cancel Click Cancel to restore your previously saved settings.
To Next Page
Loading...
