Chapter 10 Quality of Service (QoS)
P-661HNU-Fx User’s Guide
185
MAC Address Select the check box and enter the destination MAC address of the
packet.
MAC Mask Type the mask for the specified MAC address to determine which bits
a packet’s MAC address should match.
Enter “f” for each bit of the specified source MAC address that the
traffic’s MAC address should match. Enter “0“ for the bit(s) of the
matched traffic’s MAC address, which can be of any hexadecimal
character(s). For example, if you set the MAC address to
00:13:49:00:00:00 and the mask to ff:ff:ff:00:00:00, a packet with a
MAC address of 00:13:49:12:34:56 matches this criteria.
IP Address Select the check box and enter the destination IP address in dotted
decimal notation. A blank source IP address means any source IP
address.
IP Subnet
Mask
Enter the destination subnet mask.
Port Range If you select TCP or UDP in the IP Protocol field, select the check
box and enter the port number(s) of the source.
Exclude Select this option to exclude the packets that match the specified
criteria from this classifier.
Others
IP Protocol This field is available only when you select IP in the Ether Type field.
Select this option and select the protocol (service type) from TCP or
UDP. If you select User defined, enter the protocol (service type)
number.
IP Packet
Length
This field is available only when you select IP in the Ether Type field.
Select this option and enter the minimum and maximum packet
length (from 46 to 1504) in the fields provided.
DSCP This field is available only when you select IP in the Ether Type field.
Select this option and specify a DSCP (DiffServ Code Point) number
between 0 and 63 in the field provided.
TCP ACK This field is available only when you select IP in the Ether Type field.
If you select this option, the matched TCP packets must contain the
ACK (Acknowledge) flag.
Table 41 Class Setup: Add/Edit (continued)
LABEL DESCRIPTION
To Next Page
Loading...
