ZyXEL Communications VMG1312 - Page 103

103
ZyXEL Confidential
www.zyxel.com
where utx = TX unicast antenna configuration
urx = RX unicast antenna configuration
dtx = TX default (non-unicast) antenna configuration
drx = RX default (non-unicast) antenna configuration
txcore
Usage: wlctl txcore -k <CCK core mask> -o <OFDM core mask> -s <1..4> -c <core bitmap>
-k CCK core mask
-o OFDM core mask
-s # of space-time-streams
-c active core (bitmask) to be used when transmitting frames
txcore_override
Usage: wlctl txcore_override
get the user override of txcore
txchain_pwr_offset
Usage: wlctl txchain_pwr_offset [qdBm offsets]
Get/Set the current offsets for each core in qdBm (quarter dBm)
sample_collect
Optional parameters HTPHY/(NPHY with NREV >= 7) are:
-f File name to dump the sample buffer (default "sample_collect.dat")
-t Trigger condition (default now)
now, good_fcs, bad_fcs, bad_plcp, crs, crs_glitch, crs_deassert
-b PreTrigger duration in us (default 10)
-a PostTrigger duration in us (default 10)
-m Sample collect mode (default 1)
HTPHY: 0=adc, 1..3=adc+rssi, 4=gpio
NPHY: 1=Dual-Core adc[9:2], 2=Core0 adc[9:0], 3=Core1 adc[9:0], gpio=gpio
-g GPIO mux select (default 0)
use only for gpio mode
-d Downsample enable (default 0)
use only for HTPHY
-e BeDeaf enable (default 0)
-i Timeout in units of 10us (default 1000)
Optional parameters (NPHY with NREV < 7) are:
-f File name to dump the sample buffer (binary format, default "sample_collect.dat")
-u Sample collect duration in us (default 60)
-c Cores to do sample collect, only if BW=40MHz (default both)