For (NREV < 7), the NPHY buffer returned has the format:
In 20MHz [(uint16)num_bytes, <I(core0), Q(core0), I(core1), Q(core1)>]
In 40MHz [(uint16)num_bytes(core0), <I(core0), Q(core0)>,
(uint16)num_bytes(core1), <I(core1), Q(core1)>]
txfifo_sz
set/get the txfifo size; usage: wlctl txfifo_sz <fifonum> <size_in_bytes>
rate_histo
Get rate hostrogram
pkteng_start
start packet engine tx usage: wlctl pkteng_start <xx:xx:xx:xx:xx:xx> <tx|txwithack>
[(async)|sync] [ipg] [len] [nframes] [src]
start packet engine rx usage: wlctl pkteng_start <xx:xx:xx:xx:xx:xx> <rx|rxwithack>
[(async)|sync] [rxframes] [rxtimeout]
sync: synchronous mode
ipg: inter packet gap in us
len: packet length
nframes: number of frames; 0 indicates continuous tx test
src: source mac address
rxframes: number of receive frames (sync mode only)
rxtimeout: maximum timout in msec (sync mode only)
pkteng_stop
stop packet engine; usage: wlctl pkteng_stop <tx|rx>
pkteng_stats
packet engine stats; usage: wlctl pkteng_stats
wowl
Enable/disable WOWL events
0 - Clear all events
Bit 0 - Wakeup on Magic Packet
Bit 1 - Wakeup on NetPattern (use 'wlctl wowl_pattern' to configure pattern)
Bit 2 - Wakeup on loss-of-link due to Disassociation/Deauth
Bit 3 - Wakeup on retrograde tsf
Bit 4 - Wakeup on loss of beacon (use 'wlctl wowl_bcn_loss' to configure time)
wowl_bcn_loss
Set #of seconds of beacon loss for wakeup event
wowl_pattern
usage: wowl_pattern [ [clr | [[ add | del ] offset mask value ]]]
No options -- lists existing pattern list
add -- Adds the pattern to the list
To Next Page
Loading...
