ZyXEL Communications VMG1312 - Page 50

50
ZyXEL Confidential
www.zyxel.com
<port> <--priority> (ptm)
port: port number of the PTM VCC to add.
Valid values: 0-1.
Priority: normal/high/both.
Options for the add service command
Usage:
wan add service <interfacename> --protocol <bridge|ipoe|pppoe|ipoa|pppoa>
wan add service <L2interfacename> --protocol bridge
[--service <servicename>]
wan add service <L2interfacename> --protocol ipoe
[--firewall <enable|disable>] [--nat <enable|disable>]
[--igmp <enable|disable>]
[--ipaddr <wanipaddress> <wansubnetmask]
[--dhcpclient <enable|disable>]
[--gatewayifname <L2interfacename>] [--dnsifname <L2interfacename>]
wan add service <L2interfacename> --protocol pppoe
[--firewall <enable|disable>] [--nat <enable|disable>]
[--igmp <enable|disable>]
[--username <username> --password <password>]
[--pppidletimeout <timeout>] [--pppipextension <disable|enable>]
[--gatewayifname <pppinterfacename>] [--dnsifname <pppinterfacename>]
wan add service <L2interfacename> --protocol ipoa
--ipaddr <wanipaddress> <wansubnetmask
[--service <servicename>]
[--firewall <enable|disable>] [--nat <enable|disable>]
[--igmp <enable|disable>]
wan add service <L2interfacename> --protocol pppoa
[--service <servicename>]
[--firewall <enable|disable>] [--nat <enable|disable>]
[--igmp <enable|disable>]
[--username <username> --password <password>]
[--pppidletimeout <timeout>] [--pppipextension <disable|enable>]
--protocol <bridge|pppoe|pppoa|ipoe|ipoa>
The protocol of the WAN interface.
Valid values: bridge, pppoe, pppoa, ipoe, or ipoa.
Default value: bridge.
--encap <llc|vcmux>
The encapsulation type over the ATM PVC.
Valid values: llc or vcmux.
llc -
For ipoe, pppoe or bridge, it‟s RFC2684 bridged encapsulation
For pppoa, it‟s RFC2364 LLC/NLPID encapsulation