Vcmux - RFC2684 VC-MUX (null encapsulation).
Default value:
llc for bridge, pppoe, ipoe, or ipoa.
Vcmux for pppoa.
--service <servicename>
The service name of the WAN interface.
Valid values: strings of 32 characters.
Default value: <protocol>_<vpi>_<vci>.
--firewall <enable|disable>
The firewall state of the IPOE or IPoA interface.
Notice that firewall is always enabled on a PPPoE or a
PPPoA interface.
Valid values: enable or disable.
Default value: enable.
--nat <enable|disable>
The NAT state of the IPOE or IPoA interface.
Notice that NAT is always enabled on a PPPoE or a
PPPoA interface.
Valid values: enable or disable.
Default value: enable.
--username <username>
The login name of the PPPoE or PPPoA interface.
This option is only applied to a PPPoE or PPPoA interface.
The -–password option is also needed when this option is used.
Valid values: string of 32 characters.
--password <password>
The password of the PPPoE or PPPoA interface.
This option is only applied to a PPPoE or PPPoA interface.
The -–username option is also needed when this option is used.
Valid values: string of 256 characters.
--pppidletimeout <timeout>
The PPP timeout of a PPPoE or PPPoA interface.This option is only applied to a PPPoE or PPPoA
interface.
Valid values: 0 – 1090 (minutes).
0:
PPP connection is always-on.
Greater than 0:
WAN traffic will be monitored and
To Next Page
Loading...
