(D)BM - DBM mode
(F)BM - FBM mode
--ccw :
Enables special CRC workaround for Centillium modems
Options for the stop command
xdsl stop :
Options for the connection command
xdsl connection [--up] [--down] [--loopback] [--reverb]
[--medley] [--noretrain] [--L3][--diagMode][--Lo]
[--tones <xmtStart xmtNum xmtMap rcvStart rcvNum rcvMap>]
[--normal][--freezeReverb][--freezeMedley]
--up :
Starts XDSL connection in normal mode
--down :
Puts XDSL PHY in idle mode
--loopback :
Puts XDSL PHY in ATM cell loopback mode. In this modem XDSL PHY will not try to establish
connection .
--reverb :
Puts XDSL PHY in test mode in which it only sends REVERB signal
--medley :
Puts XDSL PHY in test mode in which it only sends MEDLEY signal
--noretrain :
In this mode XDSL PHY will be trying to establish connection as in normal mode, but once the
connection is up it will not retrain even if the signal is lost.
--L3 :
Puts XDSL modem in L3 power state
--diagmode :
Puts modem in diagnostic test mode
--L0 :
Puts modem in L0 mode
--tones :
To Next Page
Loading...
