set the pll to reset value
Usage: wlctl pllreset
pcieserdesreg
g/set SERDES registers: dev offset [val]
ampdu_activate_test
actiate
ampdu_tid
enable/disable per-tid ampdu; usage: wlctl ampdu_tid <tid> [0/1]
ampdu_retry_limit_tid
Set per-tid ampdu retry limit; usage: wlctl ampdu_retry_limit_tid <tid> [0~31]
ampdu_rr_retry_limit_tid
Set per-tid ampdu regular rate retry limit; usage: wlctl ampdu_rr_retry_limit_tid <tid> [0~31]
ampdu_send_addba
send addba to specified ea-tid; usage: wlctl ampdu_send_addba <tid> <ea>
ampdu_send_delba
send delba to specified ea-tid; usage: wlctl ampdu_send_delba <tid> <ea>
ampdu_clear_dump
clear ampdu counters
dpt_deny
adds/removes ea to dpt deny list
usage: wlctl dpt_deny <add,remove> <ea>
dpt_endpoint
creates/updates/deletes dpt endpoint for ea
usage: wlctl dpt_endpoint <create, update, delete> <ea>
dpt_pmk
sets DPT pre-shared key
dpt_fname
sets/gets DPT friendly name
dpt_list
gets status of all dpt peers
actframe
Send a Vendor specific Action frame to a channel
To Next Page
Loading...
