AP only (G mode): Check for beacons without NONERP element(0=Examine beacons, 1=Ignore
beacons)
pktcnt
Get the summary of good and bad packets.
upgrade
Upgrade the firmware on an embedded device
gmode
Set the 54g Mode (LegacyB|Auto||GOnly|BDeferred|Performance|LRS)
gmode_protection
Get G protection mode. (0=disabled, 1=enabled)
gmode_protection_control
Get/Set 11g protection mode control alg.(0=always off, 1=monitor local association, 2=monitor
overlapping BSS)
gmode_protection_override
Get/Set 11g protection mode override. (-1=auto, 0=disable, 1=enable)
protection_control
Get/Set protection mode control alg.(0=always off, 1=monitor local association, 2=monitor
overlapping BSS)
legacy_erp
Get/Set 11g legacy ERP inclusion (0=disable, 1=enable)
scb_timeout
AP only: inactivity timeout value for authenticated stas
assoclist
AP only: Get the list of associated MAC addresses.
isup
Get driver operational state (0=down, 1=up)
rssi
Get the current RSSI val, for an AP you must specify the mac addr of the STA
rssi_event
Set parameters associated with RSSI event notification
usage: wlctl rssi_event <rate_limit> <rssi_levels>
rate_limit: Number of events posted to application will be limited to 1 per this rate limit. Set to 0
to disable rate limit.
To Next Page
Loading...
