Chapter 3 App Tutorials
WAP6807 User’s Guide
27
3.6.1 Setting up an MPro Mesh Router and a WAP6807 with a WiFi
Connection
Follow the steps below to set up your MPro Mesh Router with the WAP6807.
1 Turn on both devices near each other. Note the power LEDs when you’re done. The power LEDs should
be steady green.
2 Download the app to your smart phone and log into the MPro Mesh Router. You may need to forget
your current WiFi connection on your smartphone.
3 Change the default SSID and WiFi key on the MPro Mesh Router; see Section 3.4 on page 24 for more
information. After applying changes, you will need to reconnect to the MPro Mesh Router again using
the new SSID and WiFi key.
4 Use WPS to copy the SSID and WiFi key from the MPro Mesh Router to the WAP6807.
5 Turn off the WAP6807 and place it where you need to extend WiFi coverage. Use the app to see if the
extender is too far from the router; see Section 3.5 on page 25 for more information.
The following table describes the WAP6807 LED behaviors when it is connected to an MPro Mesh router.
Table 12 Devices Role
Zyxel Devices MPro Mesh Router WAP6807
Role Internet Access& Mesh Network Controller Mesh Network Repeater/ AP
Table 13 LED Table (for the WAP6807)
LED COLOR STATUS DESCRIPTION
POWER Green On Device ready in Repeater mode.
Blinking Device booting. Please wait.
Amber On Device ready in AP mode.
Blinking Device is joining WiFi network. Please wait.
Red On Device failed to join the WiFi network. Check that the Zyxel MPro
Mesh Router is on with WiFi enabled.
Off Device is not receiving power. Check the power connection.
To Next Page
Loading...
