WAP6807 User’s Guide
38
CHAPTER 4
Web Tutorials
4.1 Overview
This chapter provides web configurator tutorials for setting up a secure WiFi network for your WAP6807.
• To configure basic settings such as SSID, pre-shared key or authentication mode for you WiFi network,
see Section 4.2.1 on page 38.
• To set up a secure WiFi network using the WPS button, see Section 4.2.2 on page 39.
• To set up WiFi groups for different users, see Section 4.2.4 on page 42.
• To backup/restore your configuration file or to upload latest firmware, see Section 4.3 on page 44.
4.2 WiFi Network Setup
Thomas wants to set up a wireless network so that he can use his notebook to access the Internet. In this
wireless network, the WAP6807 serves as an access point (AP), and the notebook is the wireless client.
The wireless client can access the Internet through the AP.
Thomas has to configure the wireless network settings on the WAP6807. Then he can set up a wireless
network using WPS or manual configuration.
4.2.1 Setting Up a WiFi Network
This example uses the following parameters to set up a wireless network.
1 Click Wireless > WiFi configuration to open the Wireless Overview screen. Click on the Config button for
the 2.4G/5G interface to configure the settings for the main or guest WiFi. Select WPS2PSK as the security
mode. Configure the screen using the provided parameters in the table above. Click Apply.
Table 17 Wireless Network Settings Example
SSID Example
Security Mode WPA2-PSK
Pre-Shared Key DoNotStealMyWirelessNetwork
802.11 Mode 802.11b/g/n/ax Mixed
To Next Page
Loading...
