ZyXEL Communications WAP6807 - Status Overview Screen (AP Mode)

Chapter 5 Web Configurator
WAP6807 User’s Guide
48
6 Enter the modem/router’s default static IP address. Check the IP address the modem/router has
assigned to you WAP6807 in its web configurator.
7 Enter “http:// (DHCP-assigned IP)” as the WAP6807 web address in your web browser.
8 Type the Username and Password on the device label (default) and click Login.
Figure 23 Login Screen
9 You should see a screen asking you to change your password as shown next. Enter a new password.
Click Apply to save your changes. Click Reset if you want to erase the password you entered.
Figure 24 Change Password Screen
Right after you log in, the Status screen is displayed.
5.2.1 Status Overview Screen (AP Mode)
The screen below shows the status screen in AP mode.