Chapter 5 Web Configurator
WAP6807 User’s Guide
51
The following table describes the sub-menus.
5.4 Preparing Your Computer to Access the Web
Configurator
This section shows you how to assign a static IP address to your computer.
Your computer needs to be in the same subnet as the WAP6807 in order to access the Web
Configurator. Below you will find the steps to set a static IP on both Windows 7 (Section 5.4.1 on page 51)
and MAC OS X 10.11 (Section 5.4.2 on page 53) operating systems.
5.4.1 Static IP Configuration in Microsoft Windows
Follow these steps to change your computer’s IP address in Windows 7 operating system.
1 Click the Network Icon located in the System Tray of your Task Bar. After you have clicked the icon
a small message window will appear, select Open Network and Sharing Center.
Table 21 Navigation Panel (Repeater/AP Mode)
LINK TAB FUNCTION
Status
Overview Overview Use this screen to view the WAP6807’s basic information, such as firmware
version or work mode.
System Log System Log Use this screen to view the status of events that occurred to the WAP6807.
System
Time Time Use this screen to change the WAP6807’s time and date.
Password Password Use this screen to change user password on the WAP6807.
Restore /
Firmware
Upgrade
Restore /
Firmware
Upgrade
Use this screen to backup and restore the WAP6807’s configuration (settings)
or reset the factory default settings.
Use this screen to upload firmware to the WAP6807.
Restart Restart Use this screen to restart the WAP6807 without turning the power off.
Wireless
WiFi
Configuration
WiFi
Configuration
Use this screen to configure the WiFi settings and WLAN authentication/
security settings.
To Next Page
Loading...
