ZyXEL Communications WAP6807 - Stations Screen

Chapter 8 Wireless LAN
WAP6807 User’s Guide
74
The following table describes the labels in this screen.
8.8 Stations Screen
View a detailed summary of WAP6807’s associated devices. Association means that a wireless client (for
example, your network or computer with a wireless network card) has connected successfully to the
WAP6807 (or wireless router) using the same SSID, channel and security settings.
Click Wireless > WiFi Configuration > 2.4G/ 5G Main Config > Stations to open the following screen.
Figure 49 Wireless > WiFi Configuration > 2.4G/ 5G Main Config > Stations
The following table describes the labels in this screen.
Table 31 Wireless > WiFi Configuration > Main Config > WPS
LABEL DESCRIPTION
WPS This field shows the status of the WPS on the WAP6807.
WPS Configured This field shows Yes if WPS is enabled and the wireless security key will not be changed after
the WPS connection is established.
WPS SSID This field shows the SSID of WAP6807.
WPS Auth Mode This field shows the data encryption method the WAP6807 uses.
WPS Encryp Type This field shows the AES type of data encryption.
WPS Key This field shows the wireless network key of WAP6807.
WPS mode This field shows WPS wireless network is using Push Button Configuration (PBC).
WPS Action Click this button to add another WPS-enabled wireless device (within wireless range of the
WAP6807) to your wireless network.
WPS Current Status This field shows if WPS connection has been established successfully.
Table 32 Wireless > WiFi Configuration > 2.4G/ 5G Main Config > Stations
LABEL DESCRIPTION
MAC Addr This shows the MAC address of the wireless client which is associated with the WAP6807.
TX Rate This shows the number of bytes that have been transmitted by the connected AP or client.
RSSI This shows the RSSI (Received Signal Strength Indicator) of the WAP6807’s wireless connection.
Stream SNR This Signal-to-Noise Ratio (SNR) is the ratio between the received signal power and the
received noise power.
Last RX Rate This shows the number of bytes that have been received by the connected AP or client.
Connect Time This shows the total amount of time (in seconds) the WAP6807 has been associated with the
AP or client.