ZyXEL Communications WAP6807 - Troubleshooting; 9.1 Power, Hardware Connections, and LEDs

WAP6807 User’s Guide
86
CHAPTER 9
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential problems are
divided into the following categories.
• Power, Hardware Connections, and LEDs
• WAP6807 Web Configurator Access and Login
• Internet Access
• Resetting the WAP6807 to its Factory Defaults
• WiFi Problems
• MPro Mesh Problems
• MPro Mesh App Problems
• Daisy Chain Problems
9.1 Power, Hardware Connections, and LEDs
The WAP6807 does not turn on. None of the LEDs turn on.
• Make sure the WAP6807 is plugged in to an appropriate power source. Make sure the power source is
turned on.
• Check if the power button is pressed.
• Disconnect and re-connect the WAP6807.
• Remove the WAP6807 from the outlet. Then connect an electrical device that you know works into
the same power outlet. This checks the status of the power outlet.
• If the problem continues, contact the vendor.
LED FAQ
For POWER LED:
• How do I know my WAP6807 is in Repeater mode?
A: Your POWER LED is steady green.
• How do I know my WAP6807 is booting?
A: Your POWER LED is blinking green.