Chapter 8 Wireless LAN
WAP6807 User’s Guide
73
The following table describes the labels in this screen.
8.7 WPS Screen
Use this screen to enable or disable WPS and check current WPS status.
Click Wireless > WiFi Configuration > 2.4G/ 5G Main Config > WPS to open the following screen.
Note: With WPS, wireless clients can only connect to the 5GHz or 2.4GHz wireless network using
the first SSID on the WAP6807.
Figure 48 Wireless > WiFi Configuration > 2.4G/ 5G Main Config > WPS
Table 30 Wireless > WiFi Configuration > 2.4G/ 5G Main Config > Basic (AP agent)
LABEL DESCRIPTION
SSID This field shows the SSID of the WAP6807 wireless network. The SSID identifies the Service Set
with which a wireless station is associated. Wireless stations associating to the access point
(AP) must have the same SSID.
Auth Mode This field shows the data encryption method the WAP6807 uses.
Encryption This field shows the AES type of data encryption.
Pass-phrase This field shows the wireless network key that the WAP6807 get from its uplink router.
Hidden This field shows if the WAP6807’s SSID is hidden in the outgoing beacon frame so a station
cannot obtain the SSID through scanning using a site survey tool.
Key Renewal
Interval
The Key Renewal Interval is the rate at which the WAP6807 sends a new group key out to
clients.
Apply Click Apply to save your changes back to the WAP6807.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
