Chapter 4 Repeater Mode
WRE6505 v2 User’s Guide
23
Figure 12 Status: Repeater Mode
The following table describes the labels shown in the Status screen.
Table 9 Status Screen: Repeater Mode
LABEL DESCRIPTION
Select a number of seconds or None from the drop-down list box to refresh all
screen statistics automatically at the end of every time interval or to not
refresh the screen statistics.
Click this button to refresh the status screen statistics.
Device Information
Host Name This is the WRE6505 v2’s system name you configure in the Maintenance >
General screen.
Firmware Version This is the firmware version and the date created.
Sys OP Mode This is the device mode (Section 3.1.1 on page 19) to which the WRE6505 v2
is set - Repeater Mode.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the LAN port’s IP address.
IP Subnet Mask This shows the LAN port’s subnet mask.
Default Gateway This shows the LAN port’s gateway IP address.
DHCP This shows the LAN port’s DHCP role - Client or None.
WLAN 2.4G Information
MAC Address This shows the wireless adapter MAC Address of your WRE6505 v2.
To Next Page
Loading...
