Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
57
The following table describes the labels in this screen.
9.6 AP Select Screen
Use this screen (available in repeater mode only) to choose an access point that you want the
WRE6505 v2 to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN 2.4G or Wireless LAN 5G > AP Select.
Figure 34 Network > Wireless LAN 2.4G/5G > AP Select (Repeater Mode)
Table 18 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Security Mode Select WPA-PSK or WPA2-PSK to enable data encryption.
WPA-PSK
Compatible
This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your WRE6505 v2.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the WRE6505 v2.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
