Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
58
The following table describes the labels in this screen.
Enter a Wi-Fi key
If wireless securoty is enabled on the selected AP, the following screen displays after you click
Continue in the AP Select screen. Enter the AP’s Wi-Fi key and click Continue.
Set up the WRE6505 v2’s WLAN for clients
Use this screen to configure the wireless settings between the WRE6505 v2 and its wireless clients.
The WRE6505 v2 automatically copies the SSID of the associated AP. You can set the SSID and Wi-
Fi key of the WRE6505 v2’s WLAN to be the same as those on the AP to which the WRE6505 v2
wants to connect. Click Apply to save your settings.
Table 19 Network > Wireless LAN 2.4G/5G > AP Select (Repeater Mode)
LABEL DESCRIPTION
Select Use the radio button to select the wireless device to which you want to connect.
SSID This displays the Service Set IDentity of the wireless device. The SSID is a unique name
that identifies a wireless network. All devices in a wireless network must use the same
SSID.
MAC This displays the MAC address of the wireless device.
Channel This displays the channel number used by this wireless device.
Mode This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
Security Mode This displays the type of security configured on the wireless device. When No Security is
shown, no security is configured and you can connect to it without a password.
Strength This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your WRE6505 v2 and this device.
Continue Click Continue to start the next step in the AP setup process.
Scan Again Click Scan Again to search for available wireless devices within transmission range and
update this table.
Choose Network
Manually
Select this to set up the AP manually.
WPS This button is configurable only when you enable WPS in the Wireless LAN 2.4G/5G >
WPS screen.
Click this button to connect to the selected AP via WPS.