Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
64
Figure 39 Network > Wireless LAN 2.4G/5G > WPS Device (Repeater Mode)
Figure 40 Network > Wireless LAN 2.4G/5G > WPS Device (AP Mode)
The following table describes the labels in this screen.
9.12 Scheduling Screen
Use this screen (available in AP mode only) to set the times your wireless LAN is turned on and off.
Wireless LAN scheduling is disabled by default. The wireless LAN can be scheduled to turn on or off
on certain days and at certain times. To open this screen, click Network > Wireless LAN 2.4G or
Wireless LAN 5G > Scheduling tab.
Table 24 Network > Wireless LAN 2.4G/5G > WPS Device
LABEL DESCRIPTION
WPS Use this button when you use the PBC (Push Button Configuration) method to configure
wireless stations’s wireless settings. See Section 7.3.1 on page 39.
Click this to start WPS-aware wireless station scanning and the wireless security
information synchronization.
Or input your
devices PIN
number (AP mode
only)
Use this button when you use the PIN Configuration method to configure wireless station’s
wireless settings. See Section 7.3.2 on page 40.
Type the same PIN number generated in the wireless station’s utility. Then click Go to
associate to each other and perform the wireless security information synchronization.
To Next Page
Loading...
