Chapter 5 Access Point Mode
WRE6505 v2 User’s Guide
31
5.5 Configuration Menus
Use the menu in the navigation panel to configure WRE6505 v2 features in Access Point mode.
The following screen and table show the features you can configure in Access Point mode.
Figure 16 Menu: Access Point Mode
The following table describes the sub-menus.
Table 12 Navigation Panel: Access Point Mode
LINK TAB FUNCTION
Status Status This screen shows the WRE6505 v2’s general device, system and interface
status information.
MONITOR
Monitor
Packet
Statistics
Packet
Statistics
Use this screen to view port status, packet specific statistics, the "system
up time" and so on.
CONFIGURATION
Network
Wireless LAN
2.4G
General Use this screen to configure general wireless LAN and wireless security
settings.
MAC Filter Use this screen to configure the WRE6505 v2 to block access to devices or
block the devices from accessing the WRE6505 v2.
Advanced Use this screen to configure advanced wireless settings.
QoS Use this screen to enable Wi-Fi MultiMedia Quality of Service (WMMQoS).
WPS Use this screen to enable and configure WPS.
WPS Device Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled or
disabled.
Wireless LAN
5G
General Use this screen to configure general wireless LAN settings.
MAC Filter Use this screen to configure the WRE6505 v2 to block access to devices or
block the devices from accessing the WRE6505 v2.
Advanced Use this screen to configure advanced wireless settings.
QoS Use this screen to enable Wi-Fi MultiMedia Quality of Service (WMMQoS).
WPS Use this screen to enable and configure WPS.
WPS Device Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled or
disabled.
LAN IP Use this screen to configure LAN IP address and subnet mask.
To Next Page
Loading...
