Chapter 9 Wireless LAN
WRE6505 v2 User’s Guide
53
Network Mode 2.4 GHz is the frequency used by IEEE 802.11b/g/n wireless clients.
5 GHz is the frequency used by IEEE 802.11ac/a/n wireless clients.
Select 2.4 GHz (802.11b) to allow only IEEE 802.11b compliant WLAN devices to associate
with the WRE6505 v2.
Select 2.4 GHz (802.11g) to allow only IEEE 802.11g compliant WLAN devices to associate
with the WRE6505 v2.
Select 2.4 GHz (802.11n) to allow only IEEE 802.11n compliant WLAN devices to associate
with the WRE6505 v2.
Select 2.4 GHz (802.11b/g) to allow both IEEE802.11b and IEEE802.11g compliant WLAN
devices to associate with the WRE6505 v2. The transmission rate of your WRE6505 v2 might
be reduced.
Select 2.4 GHz (802.11b/g/n) to allow both IEEE802.11b, IEEE802.11g and IEEE802.11n
compliant WLAN devices to associate with the WRE6505 v2. The transmission rate of your
WRE6505 v2 might be reduced.
Select 5 GHz (802.11a) to allow only IEEE 802.11a compliant WLAN devices to associate
with the WRE6505 v2.
Select 5 GHz (802.11a/n) to allow both IEEE802.11a and IEEE802.11n compliant WLAN
devices to associate with the WRE6505 v2. The transmission rate of your WRE6505 v2 might
be reduced.
Select 5 GHz (802.11a/n/ac) to allow both IEEE802.11a, IEEE802.11n and IEEE802.11ac
compliant WLAN devices to associate with the WRE6505 v2. The transmission rate of your
WRE6505 v2 might be reduced..
Channel
Bandwidth
Select the channel bandwidth you want to use for your wireless network.
Select 20 MHz if you want to lessen radio interference with other wireless devices in your
neighborhood.
Select 40 MHz if you want to lessen radio interference with other wireless devices in your
neighborhood.
Select 20/40 MHz to allow the WRE6505 v2 to choose the channel bandwidth (20 or 40
MHz) that has least interference.
Select 20/40/80 MHz to allow the WRE6505 v2 to choose the channel bandwidth (20 or 40
or 80 MHz) that has least interference. This option is available only when you select 5 GHz
(802.11a/n/ac) in the Network Mode field.
Security
Security Mode If the WRE6505 v2 is in repeater mode, select No Security or the available modes to match
as provided by the source AP or wireless router.
If the WRE6505 v2 is in AP mode, select WPA2-PSK, WPA-PSK or Static WEP to add
security on this wireless network. The wireless clients which want to associate to this
network must have same wireless security settings as this device. After you select to use a
security, additional options appears in this screen. See Section 9.5 on page 54 for detailed
information on different security modes. Or you can select No Security to allow any client to
associate this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are available
in this field.
Apply Click Apply to save your changes back to the WRE6505 v2.
Reset Click Reset to return to the previous menu without saving.
Table 15 Network > Wireless LAN 2.4G/5G > General (continued)
LABEL DESCRIPTION
To Next Page
Loading...
