ZyXEL Communications WRE6606 - Navigation Panel; Resetting the WRE6606

Chapter 2 The Web Configurator
WRE6606 User’s Guide
18
2.3.2 Navigation Panel
Use the menu items on the navigation panel to open screens to configure WRE6606 features.
The following table describes the icons shown in the navigation panel.
2.4 Resetting the WRE6606
If you forget your password or IP address, or you cannot access the Web Configurator, press the
WPS button for more than 10 seconds to reload the factory-default configuration file. This means
that you will lose all configurations that you had previously saved, the password will be reset to
1234.
1 Make sure the power LED is on.
2 Press and hold the WPS button. After 10 seconds, the power LED begins flashing.
3 Release the WPS button. The WRE6606 reloads factory defaults and begins to reboot.
Table 8 Navigation Panel Menu Icons
ICON DESCRIPTION
Click this icon to see the Status page. The information in this screen depends on the device
mode you select.
Click this icon to see the Monitor navigation menu.
Click this icon to see the Configuration navigation menu.
Click this icon to see the Maintenance navigation menu.