Chapter 6 Repeater Mode
WRE6606 User’s Guide
33
6.4 Repeater Mode Status Screen
Click to open the Status screen.
Figure 18 Status: Repeater Mode
The following table describes the labels shown in the Status screen.
Table 13 Status Screen: Repeater Mode
LABEL DESCRIPTION
Select a number of seconds or None from the drop-down list box to refresh all
screen statistics automatically at the end of every time interval or to not
refresh the screen statistics.
Click this button to refresh the status screen statistics.
Device Information
Host Name This is the WRE6606’s system name you configure in the Maintenance >
General screen.
Firmware Version This is the firmware version and the date created.
Sys OP Mode This is the device mode (Section 3.1.1 on page 19) to which the WRE6606 is
set - Repeater Mode.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the LAN port’s IP address.
IP Subnet Mask This shows the LAN port’s subnet mask.
Default Gateway This shows the LAN port’s gateway IP address.
To Next Page
Loading...
