Chapter 10 Wireless LAN
WRE6606 User’s Guide
62
10.5 Wireless Security
The screen varies depending on what you select in the Security Mode field.
10.5.1 No Security
Select No Security to allow wireless clients to communicate with the access point without any data
encryption.
Note: If you do not enable any wireless security on your WRE6606, your network is
accessible to any wireless networking device that is within range.
Figure 35 Network > Wireless LAN 2.4G/5G > General: No Security
The following table describes the labels in this screen.
Pre-Shared
Key
WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key
Update Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to all
clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the WRE6606.
Reset Click Reset to return to the previous menu without saving.
Table 17 Network > Wireless LAN 2.4G/5G > General (continued)
LABEL DESCRIPTION
Table 18 Network > Wireless LAN 2.4G/5G > General: No Security
LABEL DESCRIPTION
Security Mode Choose No Security from the drop-down list box.
To Next Page
Loading...
