Chapter 10 Wireless LAN
WRE6606 User’s Guide
65
Figure 37 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
The following table describes the labels in this screen.
10.6 AP Select Screen
Use this screen (available both in Client mode and Repeater mode.) to choose an access point that
you want the WRE6606 to connect to. You should know the security settings of the target AP.
To open this screen, click Network > Wireless LAN 2.4G or Wireless LAN 5G > AP Select.
Table 20 Network > Wireless LAN 2.4G/5G > General: WPA-PSK/WPA2-PSK
LABEL DESCRIPTION
Security Mode Select WPA-PSK or WPA2-PSK to enable data encryption.
WPA Compatible This field appears when you choose WPA2-PSK as the Security Mode.
Check this field to allow wireless devices using WPA-PSK security mode to connect to
your WRE6606.
Pre-Shared Key WPA-PSK/WPA2-PSK uses a simple common password for authentication.
Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.
Group Key Update
Timer
The Group Key Update Timer is the rate at which the AP sends a new group key out to
all clients.
The default is 3600 seconds (60 minutes).
Apply Click Apply to save your changes back to the WRE6606.
Reset Click Reset to reload the previous configuration for this screen.
To Next Page
Loading...
