Chapter 4 Access Point Mode
WRE6606 User’s Guide
23
Figure 11 Status Screen: Access Point Mode
The following table describes the labels shown in the Status screen.
Table 9 Status Screen: Access Point Mode
LABEL DESCRIPTION
Select a number of seconds or None from the drop-down list box to refresh all
screen statistics automatically at the end of every time interval or to not refresh
the screen statistics.
Click this button to refresh the status screen statistics.
Device Information
Host Name This is the WRE6606’s system name you configure in the Maintenance > General
screen.
Firmware Version This is the firmware version and the date created.
Sys OP Mode This is the device mode (Section 3.1.1 on page 19) to which the WRE6606 is set -
AP Mode.
LAN Information
MAC Address This shows the LAN Ethernet adapter MAC Address of your device.
IP Address This shows the LAN port’s IP address.
IP Subnet Mask This shows the LAN port’s subnet mask.
Default Gateway This shows the LAN port’s gateway IP address.
DHCP This shows the LAN port’s DHCP role - Client or None.
WLAN 2.4G Information
MAC Address This shows the wireless adapter MAC Address of your device.
SSID This shows a descriptive name used to identify the WRE6606 in the wireless LAN.
Channel This shows the channel number which you select manually or the WRE6606
automatically scans and selects.
Security This shows the level of wireless security the WRE6606 is using.
WLAN 5G Information
To Next Page
Loading...
