Chapter 10 Wireless LAN
WRE6606 User’s Guide
67
Enter a Wi-Fi key
If wireless security is enabled on the selected AP, the following screen displays after you click
Continue in the AP Select screen. Enter the AP’s Wi-Fi key and click Continue.
Figure 40 Network > Wireless LAN 2.4G/5G > AP Select (Repeater Mode)
Figure 41 Network > Wireless LAN 2.4G/5G > AP Select (Client Mode)
Set up the WRE6606’s WLAN for clients
The following screen is available in Repeater mode only. Use this screen to configure the wireless
settings between the WRE6606 and its wireless clients. The WRE6606 automatically copies the
SSID of the associated AP. You can set the SSID and Wi-Fi key of the WRE6606’s WLAN to be the
same as those on the AP to which the WRE6606 wants to connect. Click Apply to save your
settings.
MAC This displays the MAC address of the wireless device.
Channel This displays the channel number used by this wireless device.
Mode This displays which IEEE 802.11b/g/n wireless networking standards the wireless device
supports.
Security Mode This displays the type of security configured on the wireless device. When No Security is
shown, no security is configured and you can connect to it without a password.
Strength This displays the strength of the wireless signal. The signal strength mainly depends on
the antenna output power and the distance between your WRE6606 and this device.
Continue Click Continue to start the next step in the AP setup process.
Scan Again Click Scan Again to search for available wireless devices within transmission range and
update this table.
Choose Network
Manually
Select this to set up the AP manually.
WPS This button is configurable only when you enable WPS in the Wireless LAN 2.4G/5G >
WPS screen.
Click this button to connect to the selected AP via WPS.
Table 21 Network > Wireless LAN 2.4G/5G > AP Select (Client Mode and Repeater Mode)
LABEL DESCRIPTION
To Next Page
Loading...
