Chapter 7 Wireless
WX Series User’s Guide
105
Fig ure 51 Network Setting > Wireless > WMM
Note: WMM cannot be disabled if 802.11 mode includes 802.11n or 802.11ac.
The following table describes the labels in this screen.
7.7 O the rs Se tting s
Use this screen to configure advanced wireless settings, such as additional security settings, power
saving, and data transmission settings. Click Ne two rk Se tting > Wire le ss > O the rs. The screen appears as
shown.
See
Section 7.11.2 on page 113 for detailed definitions of the terms listed in this screen.
Table 26 Network Setting > Wireless > WMM
LABEL DESC RIPTIO N
WMM of SSID1~4 Select O n to have the WX Device automatically give the wireless network (SSIDx) a priority level
according to the ToS value in the IP header of packets it sends. WMM QoS (WiFi MultiMedia
Quality of Service) gives high priority to voice and video, which makes them run more smoothly.
If the 802.11 Mo de in Ne two rk Se tting > Wire le ss > O the rs is set to include 802.11n or 802.11ac,
WMM cannot be disabled.
WMM
Automatic
Power Save
Delivery (APSD)
Select this option to extend the battery life of your mobile devices (especially useful for small
devices that are running multimedia applications). The WX Device goes to sleep mode to save
power when it is not transmitting data. The AP buffers the packets sent to the WX Device until the
WX Device "wakes up". The WX Device wakes up periodically to check for incoming data.
Note: This works only if the wireless device to which the WX Device is connected also
supports this feature.
APSD only affects SSID1. For SSID2~4, APSD is always enabled.
Cancel Click Ca nc e l to restore the default or previously saved settings.
Apply Click Apply to save your changes.
To Next Page
Loading...
