Chapter 13 User Account
WX Series User’s Guide
136
13.2.1 Use r Ac c o unt Add/ Edit
Click Add Ne w Ac c o unt or the Edit icon of an existing account in the Ma inte na nc e > Use r Ac c ount to
open the following screen.
Fig ure 71 Maintenance > User Account > Add/Edit
The following table describes the labels in this screen.
Idle Timeout This field displays the length of inactive time before the WX Device will automatically log the user
out of the Web Configurator.
Lock Period This field displays the length of time a user must wait before attempting to log in again after a
number if consecutive wrong passwords have been entered as defined in Re try Tim e s.
Group This field displays whether this user has Adm inistra to r or Use r privileges.
Modify Click the Edit icon to configure the entry.
Click the De le te icon to remove the entry.
Cancel Click Ca nc e l to restore the default or previously saved settings.
Apply Click Apply to save your changes.
Table 38 Maintenance > User Account (continued)
LABEL DESC RIPTIO N
Table 39 Maintenance > User Account > Add/Edit
LABEL DESC RIPTIO N
Active Select Ena b le or Disa b le to activate or deactivate the user account.
User Name Enter a new name for the account. The Use r Na m e must contain 1 to 15 characters, including 0
to 9, a to z, and !@#%*()-_+=~,.{}[]\. Spaces are not allowed.
Password Type your new system password. The Pa sswo rd must contain 6 to 64 characters, including 0 to 9
and a to z. Note that as you type a password, the screen displays a (*) for each character you
type. After you change the password, use the new password to access the WX Device.
Verify Password Type the new password again for confirmation.
To Next Page
Loading...
