Chapter 7 Wireless
WX Series User’s Guide
108
Note: If the current channel is a DFS channel, the warning ‘Channel scan process is denied
because current channel is a DFS channel (Channel: 52~140). If you want to run
channel scan, please select a non-DFS channel and try again.’ appears.
Fig ure 53 Network Setting > Wireless > Channel Status
7.9 O pe ra ting Mo de s Se tting s
Use this screen to manually enter the SSID and security settings of the AP to which you want the WX
Device to connect. This screen allows you to set a profile so that the WX Device will automatically try to
connect to the AP specified in the profile each time the WX Device in Repeater mode is turned on.
Click Ne two rk Se tting > Wire le ss > O pe ra ting Mo de s. The screen appears as shown.
Note: The O pe ra ting Mo de is available when you select 5GHz wireless connection. (See
Section 7.2 on page 93).
To Next Page
Loading...
