Chapter 2 Hardware
WX Series User’s Guide
23
Fig ure 18 The WX3100-T0’s Rear Panel
2.3 LEDs (Lig hts)
None of the LEDs are on if the Zyxel Device is not receiving power.
Zyxel MPro Mesh router
Table 4 Panel Ports and Buttons
LABEL DESC RIPTIO N
LAN1/LAN2 Connect computers or other Ethernet devices to Ethernet ports for Internet access.
WPS
Press the WPS button once within eight seconds to enable the AP/Repeater mode.
POWER ON/OFF or DC/IN Connect the power cable and then press the power button to start the device.
RESET Press the button to return the WX Device to the factory defaults.
Table 5 LED Table (for the WX Device-1)
LED CO LO R STATUS DESCRIPTIO N
POWER
Green On Power is on or the MPro Mesh configuration process is done.
Blinking The WX Device is starting up or under the MPro Mesh
configuration process.
Red On The WX Device detects a system error.
Blinking The WX Device is upgrading firmware.
Link (With a
WiFi
connection)
Green On
The WiFi connection to the MPro Mesh router is good.
Amber On The signal is too strong. We suggest moving the WX Device away
from the MPro Mesh Router.
Red On The signal is too weak. Move the WX Device closer to the MPro
Mesh Router.
To Next Page
Loading...
