Chapter 7 Wireless
WX Series User’s Guide
110
7.10 AP List Sc re e n
You can use this screen to select an AP and enter its WiFi password to connect to the wireless network.
Click Ne two rk Se tting > Wire le ss > AP List. The screen appears as shown.
Note: The AP List is available when you select 5GHz wireless connection. (See
Section 7.2 on
page 93).
Fig ure 55 Network Setting > Wireless > AP List
The following table describes the labels in this screen.
WPS Select this to activate or deactivate the WPS method.
Click WPS button Click this to connect the WX Device to the AP using the WPS method.
Apply Click Apply to save your changes.
Cancel Click Ca nc e l to begin configuring this screen afresh.
Table 28 Network Setting > Wireless > Operating Modes
LABEL DESC RIPTIO N
Table 29 Network Setting > Wireless > AP List
LABEL DESC RIPTIO N
Connection Status
This shows whether the WX Device is already connected, attempting to
connect, or not connected to a wireless network.
Current SSID This shows the name of the AP to which your WX Device is currently connected.
# This is the index number of the AP the WX Device can detect.
Active This field indicates whether the AP is active or not.
To Next Page
Loading...
