Chapter 8 Home Networking
WX Series User’s Guide
126
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example 255.255.255.0
(factory default). Your WX Device automatically computes the subnet mask based on the IP
address you enter, so do not change this field unless you are instructed to do so.
Gateway IP
Address
Enter a gateway IPv4 address (if your ISP or network administrator gave you one) in this field.
IPv6 Setup Select how you want to obtain an IPv6 address:
Select Sta te ful to obtain an IPv6 address using IPv6 stateful autoconfiguration.
Select Sta te le ss to obtain an IPv6 address using IPv6 stateless autoconfiguration.
Select Sta tic to configure a fixed IPv6 address for the WX Device.
WAN IPv6
Address
Enter an IPv6 IP address that your ISP gave you for the WAN interface.
IPv6 Gateway
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the same
segment as your WX Device's interfaces. The gateway helps forward packets to their
destinations.
Cancel
Click Ca nc e l to restore the default or previously saved settings.
Apply Click Apply to save your changes.
Table 31 Network Setting > Home Networking > LAN Setup (continued)
LABEL DESCRIPTIO N
To Next Page
Loading...
