Chapter 1 Introduction
WX Series User’s Guide
15
Fig ure 5 Mesh Application
The following table describes the icons used in the figure.
Note: Your router must have an Internet connection whether it supports MPro Mesh or not.
Note: If your router supports Zyxel MPro Mesh, it will serve as the router controller in a Mesh
network with the WX Device.
Note: If your router does not support Zyxel MPro Mesh, your WX Device will automatically
become the AP controller.
Table 2 Icons used in Mesh Application
IC ON DESCRIPTIO N
C
Router Controller (the DX5301-B0 in Scenario 1, see
Section 4.3.1 on page
38
) or AP controller (the first WX Device in Scenario 2, see Section 4.3.2 on
page 43
)
AP Access Point
RP Repeater
C1 Client1
C2 Client2
APC Access Point coverage area
RPC Repeater coverage area
To Next Page
Loading...
